Where is fireplace damper




















The best way to check for an open damper is to simply look inside at the top of the firebox. Do this before you get a fire going! The chimney will not be visible. Some dampers are cast iron and operate on a worm gear mechanism.

Some will pivot open and closed by moving a lever forward and backward. And others might slide on a rod or bar. Regardless of how they open and close, make sure the damper is fully open before you light the kindling and get a fire established.

A fireplace damper should always be kept open while the fire is burning. Furthermore, keep the damper open until all the embers are done burning.

Smoke and dangerous carbon monoxide can enter the house. Once the ember bed is completely out, close the damper. By doing so, the warm air from your living room is not lost by moving into the fireplace and then up and out the chimney. My family room feels drafty.

The answer to this question is dependent on the specific type in your unit. When the fireplace is thoroughly cooled, you must reach into the firebox and push or lift the handle to open the plate. Top-sealing chimney dampers are significantly easier to open because the handle is mounted on the side of the fireplace wall.

As mentioned in the previous section, the amount of chimney flue dampers utilized worldwide is voluminous. To keep this post from being 10, words, we will focus on the two most common types of chimney dampers: throat and top-sealing.

These are the traditional types often found in masonry systems. It features a cast iron or steel handle that lifts a large metal plate. This plate essentially opens a door that separates the flue and firebox.

Your specific type of throat damper handle is likely either a poker, rotary, or pivot. Also known as chimney cap dampers or top-mounted, these feature a small, spring-loaded door located inside the cap, at the top of the chimney A steel cable stretches from the mounted handle, through the flue, and to the spring-loaded door in the cap. Older top-mounted styles feature a long chain as the handle, while more contemporary versions feature a black handle that you push and pull to operate.

In addition to the easy access, since the door is inside the chimney cap, it prevents debris and animals from entering your flue. When a fire is burning in the firebox, it should always be in an open position. Only close it when the system is cool and not in use. This will keep the outside air from entering the home and the inside air from escaping through the flue. A major benefit to chimney dampers is the ability to control and throttle your fires. Damper handles have notches that you will use to throttle the airflow through the flue.

Once you establish the fire, you can reduce its position by selecting a notch that narrows the opening. Unfortunately, a house full of smoke is a common signal that the damper has not been properly adjusted for fireplace use.

Think of a chimney damper like a lid for your fireplace. It is located in the flue, which is the air shaft through which smoke and air can travel in and out of your chimney, and is located above the firebox where the fire is made, and is in use both when fireplace is active and inactive.

We commonly think of chimneys as avenues for smoke to escape from your home, but they are also a way for air to come in. Knowing exactly what your chimney damper is, what it does, and how to control it will ensure better, safer, and more enjoyable fireside chats.

This helps create energy efficiency. If your chimney has a top-mounted damper, it will be controlled by a metal chain. Do you see a knob near the fireplace or a metal rod inside the firebox? If you see one of these, you have a traditional throat damper. If the knob is turned counterclockwise all the way or the rod hangs down low, it means the damper is closed. You should turn the knob clockwise, as far as it can go, or push the rod all the way up to open the damper.

If there is a metal chain in or besides your fireplace, it means that your chimney has a top-mounted damper. If the chain is tightly attached to a hook, the damper is closed.



0コメント

  • 1000 / 1000